Carbon+M5 anti-odors filter set V400, V400E, V500, V500E, V600

SKU: P000064


Carbon filter – against unwanted odors
G4/AC (EN 779:2012) / EPM2.5 60% (ISO 16890) 0.3-2.5 µm diameter particles, 60% efficiency

Activated carbon in the filter absorbs part of unpleasant odors

Filter M5 – for everyday protection of your home
M5 (EN 779:2012) / EPM10 50% (ISO 16890) 0.3-10 µm diameter particles, 50% efficiency

For the filtration of incoming air, for the daily protection of your home


We recommend replacement at least every 6 months

Suitable for OXYGEN X-Air and Easy V series O2 ventilation units:

V400, V400E, V500, V500E, V600


ATTENTION! If you utilize non-original filters, there’s a risk of harming the heat recovery ventilation unit and polluting the ventilation system with ducts.



Filters location

Replacing filters

Replacing air filters:

  • Shut down the Unit by control panel, make sure that fans have completely stopped
  • Open the lid of the filter, that you intend to change, marked by “OXYGEN” by firmly gripping
    it and pulling out
  • Use fabric handle to remove a filter
  • Insert a new filter, following ventilation flow direction indicated on filter frame – it should point
    towards center of the Unit
  • Firmly push the lid of the filter back to its place. Make sure it was tightly inserted into the Unit
  • Turn on the Unit
  • Reset filter lifetime meter, refer to sections 9.1.7 “Filter menu”, 9.2.3 “Settings menu” or 9.3.5
    “Resetting the filter lifetime meter” of Installation and operation manual, depending on type
    of controller being used.

OXYGEN V series manual