F7+M5 anti-allergic filter set V200, V200E
SKU: P000060
26,89 €
Filter F7 – for sensitive and allergic people
F7 (EN 779:2012) / EPM1 70% (ISO 16890) 0.3-1.0 μm diameter particles, 70% efficiency
Traps even the smallest dust and pollen, suitable for sensitive and allergic persons
+
Filter M5 – for recuperator protection
M5 (EN 779:2012) / EPM10 50% (ISO 16890) 0.3-10 µm diameter particles, 50% efficiency
For filtering exhaust air from the room, protects the recuperator against damage
Recommended to be replaced at least every 4 months
Suitable for O3 X-Air V series ventilation units: V200, V200E
ATTENTION! If you utilize non-original filters, there’s a risk of harming the heat recovery ventilation unit and polluting the ventilation system with ducts.
Details
+
Filters location
+
Replacing filters
Replacing air filters:
- Shut down the Unit by control panel, make sure that fans have completely stopped
- Open the lid of the filter, that you intend to change, marked by “OXYGEN” by firmly gripping
it and pulling out - Use fabric handle to remove a filter
- Insert a new filter, following ventilation flow direction indicated on filter frame – it should point
towards center of the Unit - Firmly push the lid of the filter back to its place. Make sure it was tightly inserted into the Unit
housing - Turn on the Unit
- Reset filter lifetime meter, refer to sections 9.1.7 “Filter menu”, 9.2.3 “Settings menu” or 9.3.5
“Resetting the filter lifetime meter” of Installation and operation manual, depending on type
of controller being used.
