F7+M5 anti-allergic filter set V400, V400E, V500, V500E, V600

SKU: P000063

27,89 

Filter F7 – for sensitive and allergic people
F7 (EN 779:2012) / EPM1 70% (ISO 16890) 0.3-1.0 μm diameter particles, 70% efficiency

Traps even the smallest dust and pollen, suitable for sensitive and allergic persons

+

Filter M5 – for recuperator protection
M5 (EN 779:2012) / EPM10 50% (ISO 16890) 0.3-10 µm diameter particles, 50% efficiency

For filtering exhaust air from the room, protects the recuperator against damage

 

Recommended to be replaced at least every 4 months

Suitable for OXYGEN X-Air and Easy V series O2 ventilation units:

V400, V400E, V500, V500E, V600

 

ATTENTION! If you utilize non-original filters, there’s a risk of harming the heat recovery ventilation unit and polluting the ventilation system with ducts.

Category:

Details

+
Filters location

+
Replacing filters

Replacing air filters:

  • Shut down the Unit by control panel, make sure that fans have completely stopped
  • Open the lid of the filter, that you intend to change, marked by “OXYGEN” by firmly gripping
    it and pulling out
  • Use fabric handle to remove a filter
  • Insert a new filter, following ventilation flow direction indicated on filter frame – it should point
    towards center of the Unit
  • Firmly push the lid of the filter back to its place. Make sure it was tightly inserted into the Unit
    housing
  • Turn on the Unit
  • Reset filter lifetime meter, refer to sections 9.1.7 “Filter menu”, 9.2.3 “Settings menu” or 9.3.5
    “Resetting the filter lifetime meter” of Installation and operation manual, depending on type
    of controller being used.
+
Documents

OXYGEN V series manual

PDF