M5+M5 filter set V200, V200E
25,89 €
Filter M5 – for recuperator protection
M5 (EN 779:2012) / EPM10 50% (ISO 16890) 0.3-10 µm diameter particles, 50% efficiency
For filtering exhaust air from the room, protects the recuperator against damage
Recommended to be replaced at least every 6 months
+
Filter M5 – for everyday protection of your home
M5 (EN 779:2012) / EPM10 50% (ISO 16890) 0.3-10 µm diameter particles, 50% efficiency
For the filtration of incoming air, for the daily protection of your home
We recommend replacement at least every 6 months
Suitable for O3 X-Air V series ventilation units: V200, V200E
ATTENTION! If you utilize non-original filters, there’s a risk of harming the heat recovery ventilation unit and polluting the ventilation system with ducts.
Details
Replacing air filters:
- Shut down the Unit by control panel, make sure that fans have completely stopped
- Open the lid of the filter, that you intend to change, marked by “OXYGEN” by firmly gripping
it and pulling out - Use fabric handle to remove a filter
- Insert a new filter, following ventilation flow direction indicated on filter frame – it should point
towards center of the Unit - Firmly push the lid of the filter back to its place. Make sure it was tightly inserted into the Unit
housing - Turn on the Unit
- Reset filter lifetime meter, refer to sections 9.1.7 “Filter menu”, 9.2.3 “Settings menu” or 9.3.5
“Resetting the filter lifetime meter” of Installation and operation manual, depending on type
of controller being used.
