M5+F7 O1 – anti-allergenic filter set for C series

Anti-allergenic filter set for OXYGEN C series O1 models. Best suited for spring, traps pollen.

19,98 

Filter M5 – for recuperator protection
M5 (EN 779:2012) / EPM10 50% (ISO 16890) 0.3-10 µm diameter particles, 50% efficiency

For filtering exhaust air from the room, protects the recuperator against damage

Recommended to be replaced at least every 6 months

+
Filter F7 – for sensitive and allergic people
F7 (EN 779:2012) / EPM1 70% (ISO 16890) 0.3-1.0 μm diameter particles, 70% efficiency

Traps even the smallest dust and pollen, suitable for sensitive and allergic persons

Recommended to be replaced at least every 3 months

Suitable for C series ventilation units: C180, C180E, C200, C200E, C250

Details

+
Filters location

+
Replacing filters

Replacing air filters:

  • Shut down the Unit by control panel, make sure that fans have completely stopped
  • Open the lid of the filter, that you intend to change, marked by “OXYGEN” by firmly gripping
    it and pulling out
  • Use fabric handle to remove a filter
  • Insert a new filter, following ventilation flow direction indicated on filter frame – it should point
    towards center of the Unit
  • Firmly push the lid of the filter back to its place. Make sure it was tightly inserted into the Unit
    housing
  • Turn on the Unit
  • Reset filter lifetime meter, refer to sections 9.1.7 “Filter menu”, 9.2.3 “Settings menu” or 9.3.5
    “Resetting the filter lifetime meter” of Installation and operation manual, depending on type
    of controller being used.
+
Documents

OXYGEN C series manual

PDF